Phone

020 4514 2704

Contact Mail

info@stratosgroup.co.uk

Electrical Repairs & Fault Finding

Overview

Electrical faults can occur due to wear, damage, or issues within the system, affecting performance and safety. Identifying the cause of a fault and carrying out the necessary repairs is essential to restore normal operation.

We arrange electrical fault finding and repair works across residential and commercial properties, carried out by vetted contractors. This can include diagnosing issues within circuits, identifying damaged components, and carrying out remedial works to resolve faults.

Addressing electrical issues promptly helps maintain safe and reliable operation of systems and reduces the risk of further problems.

Fault identification and repair works to restore safe and reliable electrical systems.

Our Benefits

Common Electrical Faults

Electrical systems may develop faults such as tripping circuits, power loss, faulty wiring, or damaged components. These issues can arise from ageing systems, improper installations, or general wear.

Identifying the root cause of these problems and carrying out appropriate repairs helps ensure systems remain safe and operational.

Faults that usually need investigating

  • A circuit or RCD trips repeatedly and will not reset.
  • Loss of power to part of the property.
  • Burning smells, scorch marks, warm or buzzing sockets and switches.
  • Lights flickering or dimming when appliances switch on.
  • An FI (further investigation) observation on an EICR.

How fault finding and repairs are approached

Fault finding means narrowing down the cause systematically: checking which circuits are affected, disconnecting loads, and testing insulation resistance, continuity and polarity until the faulty cable, accessory or appliance is identified. Once found, the fault is repaired or the part replaced, and the circuit retested before it is put back into use.

Some faults point to wider problems. A board without modern protection may need a consumer unit upgrade, and repeated faults across circuits may justify an inspection and test or rewiring.

Standards and landlord duties

Repairs are carried out and tested to BS 7671, the IET Wiring Regulations. Where an FI or C1/C2 observation on a rented property’s EICR leads to the repair, landlords must complete the further investigation or remedial work within 28 days, or sooner if the report says so.

What to tell us about the fault

  • What happens, when it started and whether anything changed beforehand (new appliance, water leak, building work).
  • Which circuits or rooms are affected, and a photo of the consumer unit.
  • Whether power is currently off to any area.
  • Property type, occupancy and access arrangements.
  • The most recent EICR, if available.

Report the fault via the contact page. If there is immediate danger, isolate the supply if safe to do so.

Related services

What is electrical fault finding?

It involves identifying the cause of electrical issues within a system.

Most faults can be resolved through appropriate repairs depending on the condition of the system.

Frequent tripping, power loss, or malfunctioning equipment can indicate electrical issues.

Yes. Addressing faults promptly helps maintain safety and prevent further damage.